Before measuring the jump in the desired position, it is better to accommodate the overflow, faucets and traps. The reason for this is that once the bathroom is fitted with a wall, it is difficult to make connections from the body in a narrow space. Put a little "adjustable feet on the bottom of the pan so that it can increase the edge of the pan to the desired height. Make sure you also check to its height from the length and width of the tank.
Mounting Taps
If you separateFittings for hot and cold, then would this only as you would for a washbasin. If you have a blender, so you have been granted with a gasket a long time. This seal slides over the two tails in lowering the tail through the holes in the rim. Place on top has washers and tighten the two nuts back to the mixer safe securely to the bathtub. When you order a copper tube 22 millimeters flexible and adaptable in each queue.
These tubesallow easy adjustment may be required if the joints are slightly wrong. Alternatively, add short sections of standard 22 mm (3 / 4 ") copper or plastic pipe with tap connectors in preparation for joining the title tune.
The disposal of waste and overflow
It is better to use a combination of waste and overflow unit to your bathroom. If you use a plastic hose, take the water from the overflow, so the trash. A tube with aCompression unit connects to the case, but if you're a banjo must adapt to overflow before the trap.
Now fit, spread a layer of silicone sealant under the edge of the deposit of waste or a round rubber gasket. Before inserting the tail through the hole in the floor or bathroom, sealing the thread with PTFE tape. The soil, add a plastic washer, then tighten the large back-nut, bedding the outlet to the seal or rubber gasket. Wipe the excessSealant.
Close take the case to bath in the back of waste with a separate nut.
Pass the threaded boss on the pipe to flow through the hole at the bottom of the tank. Drag a seal on the head, then with pliers the overflow gate output screw.
If you use a compression fitting overflow, close the tool and the other end of the hose to the eye of the trap is clean.
ไม่มีความคิดเห็น:
แสดงความคิดเห็น